I am considering injecting epitalon.
How would I go about preparing Epitalon from Sciwalk for injection and what dosage and schedule should be followed?
As I had stated previously, I have tried this, and a couple of others have also. I did it for a little over a month but I switched back to oral and unless you are very will versed in taking Sub-q injections, I would also advise against it. The AGAG is >98% purity and the vial that it comes in can be used for loading syringes but you have a lot of other things to worry about from getting a supply of syringes to making sure that everything is clean. It is just a lot of hassle and things to concern about when in reality, the AGAG is only a 4mer tetrapeptide that can pass through the membrane under your tongue really easily so there just is no good reason to take it Sub-q.
If, on the other hand, you are going to try this any how, I will give you these suggestions:
1. Mix with bacteriostatic water.
2. Load your syringes with the amount you will take per injection, put the cap back on the needles, put inside a ziplock bag and put the bag inside of a lock tight tupperware and put that into the freezer.
3. Make sure to wipe the location where you will take the injection with a disinfectant wipe and then let it dry before the injection.
In this way you can just take out 1 syringe at a time for use, wait about 5 minutes for it to completely thaw before use, and the rest will remain in the freezer (Freezer, not fridge like would normally be the case if just mixing for oral use in the vial).
But, I would once again like to stress the point that this really is not necessary, in my view.